MAX-11A1/380 mk2 Upper Receiver

For use with .380 ACP ammunition, this drop-in upper receiver converts your SWD M-11A1 into a much more useable subgun. Features include a full length M1913 compatible rail on top and bottom. Hard mount points for additional M1913 rails on right and left sides. Contained within the upper receiver is a heavy weight bolt assembly that telescopes over the barrel. The bolt weight is securely attached to the bolt assembly with two hardened cap screws- no welds to crack or break. This reduces the rate of fire (ROF) from 1,800 RPM down to around 700 RPM. Easily shoot single, double or triple round bursts- just count them off while its firing, it's that slow and easy. Due to the reduced ROF, muzzle rise is reduced and multiple rounds stay on target. Rate of fire is approximate and varies depending on ammunition used. Side cocking, reciprocating charging handle on left side. Designed for use with removeable AR-15/M-16/M-4 sights (not included), or can be used with just a scope installed. Comes complete with upper receiver, bolt assembly, cocking knob, barrel and manual. The MAX-11A1/380 attaches to the stock M-11A1 lower receiver without any modification to the lower receiver.

The picture above shows a MAX-11A1/380 with additional Lage Mfg. accessories that are not included with the upper receiver. Accessories are available below. Registered lower receiver and magazine is not included.

Upper Receiver

1) Top Rail 10-1/2"	3) Side Accessory Rail Mounting Points	5) 8-3/8 inch barrel length, removeable (threaded 1/2-28)
2) Bottom Rail 3"	4) Cocking Handle (reciprocating)	6) Flash Hider

• Designed for use with a M-11/9 submachinegun lower receiver.
• Requires no modification of the lower receiver to install upper.
• 670 RPM standard rate of fire. 690, 770 and 950 RPM rates of fire available.
• Side cocking- Cocking knob located on left side. Cocking knob reciprocates with bolt.
• 8" barrel threaded 1/2-28 at muzzle with 9mm "Birdcage" flash suppressor. Other barrel threads available.
• Barrel is made from chrome moly steel and finished in black oxide, rifle twist is 1:16.
• 12-1/2" long Picatinny compatible rail along top for mounting a scope or removable sights.
• 3" long Picatinny compatible rail along bottom for grip, laser, light or other accessory.
• Handstop in front of bottom rail to provide positive indexing and a repeatable grip.
• Mounting points on left and right side of foregrip for mounting additional rails.
• Steel shell deflector.
• Upper receiver is manufactured from 6061 Aluminum and finished in hard coat black anodize.

• Overall dimensions of MAX-11A1/380 mk2 upper receiver:
  • Length: 13.25"
  • Width: 1.45" to handguard, 2.30" to cocking knob.
  • Height: 3.42"
  • Weight: 3.17 pounds.

• Overal dimensions of the MAX-11A1/380 mk2 when assembled to an M-11A1 lower receiver with a 8-1/2" stock:
  • Overall length- 22-1/4"
  • Width: 1.45" to handguard, 2.30" to cocking knob.
  • Height: 6.13"
  • Weight unloaded is 5.20 pounds.
  • Weight with a loaded 32 round magazine is 6.36 pounds.

• Rate of fire: approximately 700 RPM

Use of steel cased, reloaded/re-manufactured ammo will void the warranty.